Avatar

Chris McIntyre

  • Total activity 29
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 1
  • Subscriptions 15

Activity overview

Latest activity by Chris McIntyre
  • Avatar

    Chris McIntyre commented,

    I can’t answer your exact question about the voltage but I think it’s around 3 volts. All of my vents are still running on the original batteries they came with, except for one, that I just had to ...

  • Avatar

    Chris McIntyre commented,

    I am an ecobee user and the system works together very well at this point. I have nine flair vents, and ecobee sensors in each room. Flair balances the temperatures nicely. What it doesn’t seem to ...

  • Avatar

    Chris McIntyre commented,

    If you are an ecobee user you just need one puck (unless you have a much higher than normal number of vents) to be a gateway. Flair will then use your ecobee sensor temp data to control the vents. ...

  • Avatar

    Chris McIntyre commented,

    Scheduling lets you set custom temperatures for each room at any time, 7 days a week. Yes, as far as I know your gateway puck still requires power. I have nine vents and all are controlled from...

  • Avatar

    Chris McIntyre commented,

    I only have one ecobee, and it’s an ecobee3 model. Flair is working well at this point for balancing temps between rooms, and uses the ecobee sensors well. At this point I don’t think occupancy fro...

  • Avatar

    Chris McIntyre commented,

    I only have one puck, and it is running on wired power. I don’t have this issue. As Andrew suggested, may be related to battery powered pucks only.

  • Avatar

    Chris McIntyre commented,

    I am an ecobee user and have 9 Flair vents. At this point the system does a good job of balancing room temperatures. I have ecobee sensors in each room, so I only have one puck centrally located in...

  • Avatar

    Chris McIntyre commented,

    The release changelog is specifically for firmware updates, which typically only happen every few months. Much of the work is done on the web and API side, and they can easily make changes there an...

  • Avatar

    Chris McIntyre commented,

    I have had good success with using a Flair with ecobee, but typically have left the ecobee in control of the set point. I’m curious why you would want Flair to control the set point. Guessing maybe...

  • Avatar

    Chris McIntyre commented,

    Just wanted to note you can check vent status using the statistics page. I agree it would be nice to have this indicated on the home screen as well.