During initial setup, you must select the type of installation you will be performing. Brief explanations of the current options are below:
- Staged heating
- Static pressure sensor
- Networking only
Staged Heating - If you will be wiring the Bridge Pro to boiler or electric baseboard zones choose this option. You will be walked through the install step-by-step in the Flair app. Once configured Flair will be able to engage and disengage the 2nd stage heating as needed based on the outdoor temperature or via the indoor needs.
Static pressure sensor - If you are installing the Bridge Pro and will be wiring up the Flair Static Pressure kit choose this option. Once Flair is able to read the static pressure for your system it's operation becomes much more intelligent and will be able to dynamically control the number of Smart Vents that can close. If you are also wiring the Bridge Pro to control a 2 or 3-speed system fan we will be able to dynamically adjust the fan speed based on current conditions.
Networking only - You can use a Bridge Pro as the communication hub of a Flair home even if you are not wiring it up to any equipment. This allows you to use it as a Flair Bridge would be used but also allows for future wiring of HVAC equipment or controls.