Welcome to Flair!
Let's get started with setup!
On this page:
- Installing your Smart Vents
- Setting up your Puck with a Smart Thermostat
- Setting up your Puck with an IR Device
- Do You Need a Second Gateway?
- The Flair Owner's Manual
- Using a Puck as a Remote Sensor
- Need More Help?
This page will help you set up your Flair system. All the videos featured on this page are available on our Youtube Channel. Be sure to visit our Youtube Channel and subscribe to be informed of any new videos!
If you ordered Smart Vents, this video will walk you through how to install your Smart Vents into your floor, wall, or ceiling ducts.
This video will walk you through how to set up your first (Gateway) Puck with a Smart Thermostat. Check out the section below on setting up your Puck with an IR Device if you have a Minisplit, Window AC, or Portable.
This video will walk you through how to set up your first (Gateway) Puck with an IR device such as a Minisplit, Window AC, or Portable.
If you have more than ten Flair devices (the total number of Pucks plus Smart Vents), you may need to set up a second Gateway Puck. Please check flair.co/large-systems to see if you will need more than one Gateway Puck. Some large Flair Networks may require more than one Gateway Puck.
The Flair Owner's Manual provides in-depth information on all aspects of your Flair system. We recommend reading it to learn more about how your Flair system will work.
This application guide will show you how to use your Puck as a Remote Sensor with your Smart Thermostat (ecobee, Honeywell T9 and T10, etc). Click here to access our remote sensor Application Guide.
If after consulting these resources, you are still experiencing an issue with your Flair products, you can create a support ticket by emailing firstname.lastname@example.org.