Avatar

Eric Thomas

  • Total activity 10
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 3

Activity overview

Latest activity by Eric Thomas
  • Avatar

    Eric Thomas commented,

    This is great to hear Mathew! I do not own a 3D printing business, but I looked into doing this a while back. I knew it was only a matter of time before someone stepped up. Thanks for doing this.

  • Avatar

    Eric Thomas commented,

    Why not provide adaptor plates like keen does? I adapted one of theirs to fit a flair unit and it works great. I don't think there is pent up demand for additional smart vent sizes. There is pent-...

  • Avatar

    Eric Thomas created a post,

    Implications of Active/Inactive Occupancy Flair+Ecobee

    Hoping someone can help me understand how Flair uses occupancy information for rooms. I'm using my Ecobee as the primary controller thermostat and have comfort settings configured for Daytime, Nigh...

  • Avatar

    Eric Thomas commented,

    Thanks Finn. I didn't notice the notification when this occurred previously, but I'll watch for it in case this happens again. I appreciate the responses. Regards, Eric  

  • Avatar

    Eric Thomas commented,

    @Finn, I have all the Flair notifications enabled. However, do any of these notifications trigger when a room goes offline or when Flair loses the account linkage to my Ecobee account. Specifically...

  • Avatar

    Eric Thomas commented,

    I'm also in Texas with 8x10 vents in the majority of the house, so I'm holding off on buying more vents until I can get an 8x10. For one of my rooms, I bought the Keen trim kit for 8x10 (KHTRMKT810...

  • Avatar

    Eric Thomas commented,

    I added my first couple of Flair vents a couple of weeks ago to try to try to narrow the temperature deltas between a few rooms in my house. First few days showed real progress with two Flair vents...