Sal
- Total activity 296
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 136
- Subscriptions 74
Activity overview
Latest activity by Sal-
Sal commented,
Hi Flair,Just wanted to bump this thread up again.Depending on if Canada is a big enough market for you, would you consider a Canadian warehouse, amazon.ca, homedepot.ca?
-
Sal commented,
I would definitely use a vent-specific priority feature.I have one puck in the basement that will soon have 7 vents in its room. In the summer when backpressure limits the number of basement vents ...
-
Sal commented,
Hi Scott, try searching the forum for "average temperature". There's lots of discussion on using the peak vs average of all sensors.
-
Sal commented,
While we're looking at reodering the rooms, maybe we could also add more rooms wide.Currently its only 3 rooms wide....when we have 22" 1080p monitors. Why set a fixed number of 3, when our screens...
-
Sal commented,
Hey Brian,Have a look at this official blog post by Flair:Do I Need to Replace All my Vents? – Flair For my house, I have 1600 sq.ft per floor, and I've only put in 8 Flair vents: 4 upstairs and 4 ...
-
Sal commented,
I think you're looking for the setting under: Home Settings > Thermostats > Smart + Non-smart Vents Used by This Thermostat.You enter in the total number of vents in your HVAC system, and flair cal...
-
Sal commented,
Hey Jeff, the back pressure limit is a feature meant to protect your equipment. You wouldn't want to close more than that, otherwise you risk an expensive repair bill. The HVAC motor can only handl...
-
Sal commented,
+1
-
Sal commented,
Is it possible to change the settings to show the finest granularity data for an 8h period instead? I remember it used to be much larger than 2h before, and this new 2h window makes troubleshootin...
-
Sal commented,
So, using the temperature sensor in the dyson fan to control a flair vent?I guess if you already have a few fans and don't want to buy a few pucks, the support team might be able to give you an ans...