Sal
- Total activity 295
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 135
- Subscriptions 74
Comments
Recent activity by Sal Sort by recent activity-
I also have a main floor and a built out basement. I have 4 flair vents upstairs (1800 sq ft), and 4 flair vents downstairs (ceiling mounted). Not all my vents are flair.I am trying to avoid freezi...
-
Hi Dan, Thanks for the recommendation and quick reply. Will do.Cheers,
-
Hi Dan,Yes, the fireplace is in the basement. The basement also has central hvac vents. Most homes which have gas fireplaces also have hvac vents in the same room.My basement has 4 smart vents, 1 p...
-
Hi Dan,My apologies, perhaps I should expand more. My home has central hvac (furnace + ac), I have 8 smart vents and 2 pucks split evenly between the basement and main floor. All vents get their ai...
-
Most natural gas fireplaces I have seen operate on a low voltage thermopile and either a battery powered or bimetallic passive thermostat.Is there a way of adding a generic heat source, which is no...
-
I agree, but want to make sure a key point isn't overlooked:"Otherwise the vent should remain closed."Keeping the vent closed would prevent cold air from falling back down through the vents into th...
-
There is a firmware option to select if the puck is hardwired... its either a gateway or a sensor.Backlight isn't in the hardware, so its not an option as far as I can tell.
-
+1 for some sort of fan only operation mode. Using Nest + Flair.
-
I have the same issue.Basement vents are on the ceiling. So, as soon as my furnace turns off the hot air rises through the vents to the upstairs.
-
Hey Jeff, the back pressure limit is a feature meant to protect your equipment. You wouldn't want to close more than that, otherwise you risk an expensive repair bill. The HVAC motor can only handl...