Pieter Viljoen
- Total activity 32
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 9
Activity overview
Latest activity by Pieter Viljoen-
Pieter Viljoen commented,
I replaced three pucks with one bridge centrally located, vents in some rooms kept going offline, bought a second bridge, fewer vents offline but one vent is almost always offline, just ordered a t...
-
Pieter Viljoen commented,
Ok, thx, will give it a try this weekend.
-
Pieter Viljoen created a post,
How to convert from using pucks as gateways to using a bridge?
What is the process for removing the pucks I use as gateways and installing a bridge instead? If required, can I install more than one bridge? (I currently use three pucks as gateways and ?I still ...
-
Pieter Viljoen commented,
Very nice, my 3D printer bed was not big enough for a single piece.
-
Pieter Viljoen commented,
With auto-away now disabled (always active), and the hysteresis set to 0.5F by Flair, and I understand the UI quirkiness, things are working much better. I did consider switching to Flair as setpoi...
-
Pieter Viljoen commented,
I had some 1.5mm thick white acrylic pieces cut by Ponoko, see here for models: https://www.autodesk.com/community/gallery/project/173188/flair-vent-flanges
-
Pieter Viljoen commented,
James, yes, thank you. The confusion stems from the UI showing current state only, and not reason, this is an opportunity to improve the UX. To explain what I mean with the UX; AC on, room too ho...
-
Pieter Viljoen commented,
For the community I'll share my concern here, support has been responsive to offer changing the back pressure algorithm, but has not yet addressed my concern about their described method of operati...
-
Pieter Viljoen created a post,
AC on, vents remain closed even when room temp is above setpoint?
Now that it's getting hot here and AC on, I'm tracking Flair's for the first summer, winter seemed to work very well. Per the Ecobee app and dashboard setpoint is 75 and AC is on, 4 rooms with ecob...
-
Pieter Viljoen commented,
Glad HA is already supported, even if by a 3rd party, I submitted my auth request, can't wait to try it out. Support sent me a cool graph of signal strength over time (troubleshooting a vent that o...