Pieter Viljoen
- Total activity 32
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 9
Comments
Recent activity by Pieter Viljoen Sort by recent activity-
Very nice, my 3D printer bed was not big enough for a single piece.
-
James, yes, thank you. The confusion stems from the UI showing current state only, and not reason, this is an opportunity to improve the UX. To explain what I mean with the UX; AC on, room too ho...
-
I replaced three pucks with one bridge centrally located, vents in some rooms kept going offline, bought a second bridge, fewer vents offline but one vent is almost always offline, just ordered a t...
-
Ok, thx, will give it a try this weekend.
-
With auto-away now disabled (always active), and the hysteresis set to 0.5F by Flair, and I understand the UI quirkiness, things are working much better. I did consider switching to Flair as setpoi...
-
I had some 1.5mm thick white acrylic pieces cut by Ponoko, see here for models: https://www.autodesk.com/community/gallery/project/173188/flair-vent-flanges
-
For the community I'll share my concern here, support has been responsive to offer changing the back pressure algorithm, but has not yet addressed my concern about their described method of operati...
-
Glad HA is already supported, even if by a 3rd party, I submitted my auth request, can't wait to try it out. Support sent me a cool graph of signal strength over time (troubleshooting a vent that o...
-
Support wrote: You can split your Flair system into two homes: one home for upstairs and one home for downstairs. That will allow you to control them independently. That seems rather unintuitive, w...
-
Let's assume for a moment that my home is what it is, and that you asking me to fix my home and change my way of operation is not an option, and we focus on the issue with Flair? The Flair UI has o...